Because if the temperature of the hardware spring is very high, the malleable mold of the raw material will be reduced, which will cause the bearing capacity of the elastic yellow to become smaller and the bending strain to be reduced. Therefore, to promote it to work at high temperature, we must master its elastic coefficient, but also must calculate the damage of reduced bearing capacity to elastic yellow performance parameters. According to relevant regulations, the shear strain rate of the general elastic yellow must be adjusted to some extent if the temperature in the working time is higher than 60 degrees.

The elastic yellow fixing system uses alloy steel to make the elastic yellow. The selection should be based on the stress field specifications of the load of the elastic yellow and its characteristics to identify its compressive strength. However, if the judgment split of the plane design drawing appears, it may be explained that it is caused by the compressive strength.

If the hardware spring is used in experimental instruments or electronic inside, most manufacturers will use the constant plasticity of aluminum alloy profiles, because its linear expansion coefficient change is very small, which can achieve its accuracy is not easy to suffer from changes in the average temperature.

In the selection of raw materials, the processing performance of steel must be paid attention to, spring custom manufacturers this point on the quality of hardware spring is relatively large.